How To Adjust A Garage Door Gap

Home » Blog » How To Adjust A Garage Door Gap

Table of Contents

No matter how much care and maintenance one caches for certain things, there will always be that chance for things to take an inexplicable turn.

It could be a slow and gradual cleavage, worse, a sudden snapping of something.

Be that as it may, one can never know when exactly things could go awry.

The terrifying thing of all, moreover, is that these complications could account for other severe damages.

While it is true that the best cure is prevention, there are just circumstances where the saying is not applicable at all.

Being equipped, however, with the necessary knowledge in handling such dilemmas never did anyone wrong.

Garage doors, for this matter, are enormous slabs of material with a most considerable weight that homeowners should be wary of from time to time.

While the complications for these doors could vary in intensity, even a tiny failing could prove deadly if not repaired immediately.

As such, garage door gaps, while seemingly less alarming than most inconveniences, can still shepherd in dangers one would not even expect to happen.

This list, therefore, seeks to aid garage owners on how to adjust a garage door gap.

Check the garage door stops

In order to determine which are the garage door stops, simply look out for the strips of trim that are running along each side of the garage door along the top of the opening of the door.

These stops cover the gaps that are usually found on the edges of the door as well as the jambs.

You can fill the gaps along the edges by covering them and by adding a significant weatherstripping or weather seal through the act of adding a flexible flap or, as an alternative, a flange, which overlaps on the door whenever it is closed.

If the steps above do not work, it means that you need to move them, most usually closer to the proximity of the door.

If not, then they should be replaced.

Inspect the tracks

Oftentimes, the garage door stops might appear alright, yet the door is still not entirely vertical when it is closed.

If that is the case, inspect closely the vertical sections that are on the roller tracks which are on the sides of the door.

These vertical sections should be plumb and must hold the door at a significant distance from the stops at the side, in the assumption, of course, that these stops themselves are all plumb.

The tracks are positioned on the brackets that have slotted holes in them.

You can fix these by loosening the bolts that are mounted and move the tracks a little so that the door is moved close to the plumb and the stops.

Afterward, simply tighten the bolts once again.

Configure the limit switches

This is the case for the garage door that does not close all the way down, so there are some noticeable gaps at the bottom.

Garage door seals that are quite flexible are relatively easy targets for stray animals that are instinctively goaded by their need to chew.

In order to discourage such behavior, you can configure and adjust the door’s limit switches.

As a result, the seal is then compressed within the foot of the garage door and the floor itself.

These limit switches are used to control the last position of the garage door, and they are mostly found at the top of the opener.

Change the seal

If there are some gaps that are still not solved by the steps mentioned above, there is a chance that the seal that is installed below is behind the gaps.

This is because the wear and tear might be taking a toll on the seal.

You can replace the seal by yourself by getting a brand new one in a nearby store.